Stryker GoBed II MedSurg Bed FL28C Guide D'utilisation page 38

Bed Extender without Scale - FA64164
The bed extender is designed to temporarily increase the mattress support by 10" on beds not equipped with the
optional scale system . It also allows the installation of an 80" or 84" long mattress . A cushion (DM64063 for a 6" thick
mattress) must be ordered separately to accompany the extension .
WARNING
• The bed exit system must be adjusted if this accessory is added when either system is in operation . Refer to the
"Add / Remove Equipment" procedure
• The surface added by the bed extender is not included in the area monitored by the Bed Exit system .
• Do not perform this procedure while a patient is in the bed .
INSTALLATION
Tools Required:
• #2 Phillips Screwdriver
Procedure:
1 . Apply the brakes .
2 . Unplug the bed from the wall socket .
3 . Remove the foot board .
Configuration with 80" Mattress
Support
assembled
Return To Table of Contents
1-36
(page 1-21) .
Configuration with 84" Mattress
Note the position of the foot
end mattress retainer .
280C-009-001 REV B www.stryker.com