Angelo Po AT 61G-GW-GR-GWR Manuel D'utilisation page 84

Alarm Fault
Electrical component com-
E10
partment has overheated.
E11
Electronic circuit board dia-
E13
gnostics tripped.
E14
E15 ROI pre-fi lter expired.
E16 Osmosis membrane expired.
The humidity probe has failed
E19
or is not properly connected.
E20 Setup error
The washing cycle has been
E21 interrupted because there is
no cleaner.
The washing cycle has been
E22 interrupted because there is
no descaling cleaner.
The washing cycle has been
E23 interrupted during the fi nal sa-
nitization stage.
E24 Automatic cleaning system fai-
E26 lure.
System fi lling procedure not
E25
GB completed.
E27 Failure test gas
E28 Valve has failed to close/open.
Core probe not inserted in the
E29
food.
E30 Faulty panel board.
E32 Faulty drain valve.
There is no drain water, or
E33 there is insuffi cient water pres-
sure during washing.
E34 Washing error.
3354462_ATG_ut_GB
Remedy
The oven solves the problem
on its own.
Inform the after-sales service.
Replace the ROI pre-fi lter as
soon as possible.
Replace the ROI osmosis mem-
brane as soon as possible.
Inform the after-sales service
Inform the after-sales service
Check the pipe position and
the level of cleaner in the tank;
top up if necessary and restart
the washing cycle.
Check the pipe position and
the level of descaling cleaner
in the tank; top up if necessary
and restart the washing cycle.
Press RESET and rinse the co-
oking chamber thoroughly by
hand.
Check that no residues of cle-
aning products have been left
inside the cooking chamber.
Check the position of the pipe
and the level of the descaling
in the container; if necessary,
top it up and re-launch the au-
tomatic cleaning cycle.
Inform the after-sales service
Press Reset.
Insert the core probe.
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
- 38 -
Notes
The oven's functions are ena-
bled so cooking cycles can be
carried out.
The oven's functions are disa-
bled so no cooking cycles can
be carried out.
The oven's functions are ena-
bled so cooking cycles can be
carried out.
The oven's functions are ena-
bled so cooking cycles can be
carried out.
The oven's functions are ena-
bled so cooking cycles can be
carried out.
The oven's functions are disa-
bled so no cooking cycles can
be carried out
If the problem persists, call the
after-sales service.
If the problem persists, call the
after-sales service.
If the problem persists, call the
after-sales service.
If the problem persists, call the
after-sales service The oven's
functions are enabled so coo-
king cycles can be carried out.
If the problem persists, call the
after-sales service.
The oven's functions are ena-
bled so cooking cycles can be
carried out
Inform the after-sales service.
The oven's functions are ena-
bled so cooking cycles can be
carried out.
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
ENGLISH