Changing The Ignition Plug; Appliance Decommissioning, Demolition And Disposal - Angelo Po AT 61G-GW-GR-GWR Manuel D'utilisation

CHANGING THE IGNITION PLUG

To carry out this operation, proceed as follows.
1) Undo the screws to remove the side panel (A).
2) Open the tangs (B) and remove the guard (C).
3) Undo the nuts (D) to remove the ignition plug unit (E).
4) Replace the guard and close the tangs when done.
GB

APPLIANCE DECOMMISSIONING, DEMOLITION AND DISPOSAL

When decommissioning the appliance, a series of procedures must be carried out to ensure that
the appliance and its components are not a hindrance and are not easily accessible.
To ensure that the appliance cannot constitute hazards for people or the environment, all energy
sources (electricity, etc.) must be disconnected and rendered unusable, and any liquids present
must be drained (lubricants, fl uids, etc.).
Place the appliance in a suitable area which is not easily accessible, with barriers to prevent any-
one from accessing it.
When scrapping, sort all components by chemical characteristics and dispose of them separately
in accordance with the relevant legal requirements.
Important
Do not dump non-biodegradable products, lubricating oils, and non-metallic components (rub-
ber, PVC, resins, etc.) in the environment. Dispose of them in compliance with the relevant laws.
3354462_ATG_inst_GB
A
E
C
- 18 -
B
D
D
ENGLISH