Relay Output Connection - Lenze 8200 vector Instructions De Montage

5 Electrical installation

Relay output connection

Relay output connection
Function
X1.2/K11 Relay output
normally−closed contact
X1.2/K12 Relay mid−position
contact
X1.2/K14 Relay output
normally−open contact
PES HF shield termination by PE connection through shield clamp
)
Note!
Switching of control signals:
ƒ
Use shielded cables
–
HF shield termination by PE connection
–
The minimum load for switching the signals through correctly is 12 V and 5 mA.
–
Both values have to be exceeded at the same time.
Switching of mains potentials:
ƒ
Unshielded cables are sufficient
–
For the protection of the relay contacts a corresponding suppressor circuit is
ƒ
absolutely required for an inductive or a capacitive load!
The service life of the relay depends on the type of load (ohmic, inductive or
ƒ
capacitive) and the value of the switching capacity.
The message that is output can be changed in code C0008 or C0415/1.
ƒ
124
Relay position Message
(activated) (Lenze setting)
opened
closed
l
Technical data
TRIP
AC 250 V/3 A
DC 24 V/2 A ... DC 240 V/0.16 A
TRIP
EDK82EV113 DE/EN/FR 11.0
8200vec013