Front Body Mount; Hubs And Wheels - Reely ROAD Ranger Notice D'emploi

n) Front body mount
The front body mount requires a small plastic part (see the
circle in the figure on the right) to be attached to the shock
tower with a self-tapping screw. Later, the car body will be
attached to this with a split pin.
o) Hubs and wheels
Place the remaining "K2" bearings onto all axle stubs if
you have not done so already. Then slot the metal pin into
the opening on the wheel axle. The plastic nut needs to be
placed over this pin.
Ensure that the nut is correctly positioned - the slotted side
must be slid over the metal pin.
Finally push a wheel onto each axle and screw on the stop
nuts. Do not fail to observe the correct orientation of the
stop nuts - the rounded side should face outwards.
63