Reely ROAD Ranger Notice D'emploi page 57

Mount the two holders for the steering lever and the
servo saver as in the figure on the previous page.
The one long servo rod "LA2" will later be mounted
between the steering rod and the servo arm.
The counter-sunk screws "S6" (M3x6mm) are then
used to screw the preconstructed holders "C1" to
the chassis.
The "S4" screws (M3x10mm) serve for the mounting
of the servo rods "LA1" and "LA2".
The "S5" screws (flat-head M3x10mm) serve for the
mounting of the plastic rod "VS1" to the steering rods
("C4" and "C5").
The servo saver (the component with the spring)
serves later in protecting the servo from damage
caused by external forces affecting the steering.
S4 (M3x10mm)
LA2
S5 (M3x10mm)
VS1
S6
(M3x6mm)
SR2
C1 C2
LA1
SR1
C7
SR2
C1 C3
C6
C5
C4
57