Installation; Pressure Transmitter Installation; Display Unit Upgrades - Burkert 8326 Manuel Utilisateur

4

Installation

The device should be installed/operated in accordance with the regulations of ElexV,
the Device Safety Regulation, this operating manual and generally recognized indus-
try standards.
4.1

Pressure Transmitter Installation

The pressure transmitter's diaphram should not come into contact with
hard or sharp objects.
Attention
Installation Using a Weld-on Adapter:
• Insert a filler piece (a pressure transmitter dummy) into the weld-on adapter.
• Weld the adapter into the container/pipe wall (section-weld process).
• Remove the filler piece.
• Install the pressure transmitter in the weld-on adapter.
4.2

Display Unit Upgrades

The display unit can be easily upgraded at any time.
• Remove the housing cover and the supporting string.
• Attach the display unit's supporting string to the same place.
• Plug the display unit's connector into the appropriate jack.
The display unit can be mounted at 90° angles.
• Fasten the display unit with screws.
When installing the display unit, make sure that the connection cable
and the supporting string are not kinked or pinched. If the cable is
damaged, correct function may be impaired.
Attention
On EX-Model the Ex-protection of the transmitter will no longer exist.
Subject to technical changes without notice.
GB-11
Pressure Transmitter 8326
Installation