Key Functions; The Programming Mode - Burkert 8326 Manuel Utilisateur

6.2

Key Functions

Button
6.3

The Programming Mode

The transmitter can be programmed before or after installation.
The keypad is activated and the device can be programmed by simultaneously press-
ing the "esc" and "ok" keys (for 2 sec.). This method is used to access the main
menus. Each main menu has one or more sub-menus and each sub-menu, may have
its own sub-menus.
The keypad becomes inactive after 10 min. of disuse. All settings will de-
fault to previously stored values. Only settings that have been confirmed
with the "OK" function are stored.
A change in the starting measurement (zero point) has no effect on the
measurement span. Likewise, a change in the span has no effect on the
starting measurement.
An error signal occurs when the zero point or span settings fall outside of
the sensor's nominal pressure range during calibration with pressure.
Nothing is saved.
Subject to technical changes without notice.
GB-21
Operation of Transmitters with Displays
Main Menu
back to the previous
menu option
forward to next menu
option
back to value display
without saving
to the sub-menu
activate keypad (push simultaneously; 2 s)
Pressure Transmitter 8326
Functions
Sub-menu
back to the previous
menu option
forward to next menu
option
back to main menu
without saving
to the edit functions
Edit Functions
increase value
decrease value
back to the sub-menu
without saving
save value