Housing Reconfiguration - Burkert 8326 Manuel Utilisateur

•
All functions are programmable once the pressure transmitter has been upgraded
with a display unit. The adjusted parameters are stored after the display unit is re-
moved.
The display unit can be rotated in 300°, so that it can be read under various installation
conditions. The housing cover with built-in display can be fastened to the housing at
all four side positions.
4.3

Housing Reconfiguration

Rotate the housing of the display unit in order to be able to read the display from
above when the pressure transmitter is installed in an upright position.
• Loosen the 4 internal hexagonal screws.
• Lightly lift off the housing with the display unit.
• Carefully turn the housing by 180°.
• Re-tighten the screws.
When tightening the 4 hollow screws, make sure that they are ade-
quately and securely seated in order to ensure that the transmitter is
properly sealed.
Attention
Subject to technical changes without notice.
Pressure Transmitter 8326
Installation
Connection Cable
Supporting String
GB-12