Operating instructions Distance measuring device DL100 – EtherNet/IP
2.1.6. Explicit write of an attribute within the position sensor object
•
Choose service "Set Attribute Single"
•
Class 0x23, Instance 1
•
Choose for instance attribute 15 (Position Resolution)
•
Change resolution to 1mm => 0x2203
•
Change endianes => 0x0322
•
Send Request
•
First byte 0x90 => success
•
Go to the previous section an observe that the position value changed to 0xC8 => 200. This is
expected as the resolution was changed from 1/10mm to 1mm.
82
© SICK AG • Subject to change without notice • 8019720/ZVZ7/2018-03-22