SICK DL100 Pro Notice D'instructions page 72

Operating instructions Distance measuring device DL100 – EtherNet/IP
106 Reset Preset
107 Position
Resolution
Attribute Name
120 MF1 Setup
Active Level
121 MF1 Setup
Function
122 MF1 Setup
Service
123 MF1 Setup
Service
124 MF1 Setup
Service
125 MF1 Setup
Service
126 MF1 Setup
Service
127 MF1 Setup
Service
72
Writing 0x4xxxxxxx will reset a previously applied preset.
Bit
31
30
29..0
BOOL A 0-1 transition will reset the previously applied preset.
UDINT Scale in um (1-100000). When attribute 15 is set to 0x0808, the
user scale, defined within attribute 107, is applied on attribute 10.
The user scale in attribute 107 is set in um. Thus, when attribute 15
is set to 0x0808 and attribute 107 is set to 100, the value in
attribute 10 is scaled to 0,1mm.
MF1 Configuration
Type
ENUM Active level of MF1. Can either be HIGH (0) or LOW (1).
ENUM Function of MF1. Can be one of:
OUTPUT_DISTANCE_THRESHOLD (0)
MF1 is an output and is toggled when attribute 10 exceeds/falls
under attribute 128/129.
OUTPUT_VELOCITY_THRESHOLD (1)
MF1 is an output and is toggled when attribute 24 exceeds/falls
under attribute 130/131.
OUTPUT_SERVICE
MF1 is an output and is toggled by a logical OR over all active
service attributes 122-127.
INPUT_LASER_OFF
MF1 is an input and can be used to switch the laser on/off.
INPUT_PRESET_STATIC
MF1 is an input and can be to apply a preset value (attribute 132).
BOOL Plausibility Warning and Error
Disabled (0, default), Enabled (1):
If disabled, Error and Warning bits are not considered when
attribute 121 is set to OUTPUT_SERVICE.
BOOL Level Warning and Error
Disabled (0, default), Enabled (1):
If disabled, Error and Warning bits are not considered when
attribute 121 is set to OUTPUT_SERVICE.
BOOL Laser Warning and Error
Disabled (0, default), Enabled (1):
If disabled, Error and Warning bits are not considered when
attribute 121 is set to OUTPUT_SERVICE.
BOOL Temperature Warning and Error
Disabled (0, default), Enabled (1):
If disabled, Error and Warning bits are not considered when
attribute 121 is set to OUTPUT_SERVICE.
BOOL Device not ready
Disabled (0, default), Enabled (1):
If disabled, bit is not considered when attribute 121 is set to
OUTPUT_SERVICE.
BOOL Heater active
Disabled (0, default), Enabled (1):
If disabled, bit is not considered when attribute 121 is set to
OUTPUT_SERVICE.
© SICK AG • Subject to change without notice • 8019720/ZVZ7/2018-03-22
Name
Activate A 0-1 transition will apply the preset
value contained in bit 29-0
Reset A 0-1 transition will reset the
previously applied preset.
Preset Preset value in two's complement. It
is assumed that the value is scaled to
attribute 15.
Description
Description
(2)
(3)
(4)