Physical Layer Configuration - SICK DL100 Pro Notice D'instructions

Operating instructions Distance measuring device DL100 – EtherNet/IP

2.1.4. Physical layer configuration

•
Go to the Ethernet Link tab
•
Read attribute 6 (Interface control) by clicking "Get_Attribute"
o If auto-negotiate is turned on the device will ignore all other parameters within attribute
6.
o Forced Duplex Mode 0 => half duplex, 1=> full duplex
o Forced Interface Speed can be set 10 and 100.
80 © SICK AG • Subject to change without notice • 8019720/ZVZ7/2018-03-22