SICK DL100 Pro Notice D'instructions page 73

128 MF1 Setup
Threshold
Position
129 MF1 Setup
Hysteresis
130 MF1 Setup
Threshold
Velocity
131 MF1 Setup
Velocity Sign
132 MF1 Setup
Static Preset
Attribute Name
133 MF2 Setup
Active Level
134 MF3 Setup
Function
135 MF2 Setup
Service
136 MF2 Setup
Service
137 MF2 Setup
Service
138 MF2 Setup
Service
139 MF2 Setup
Service
140 MF2 Setup
Service
141 MF2 Setup
Threshold
Position
142 MF2 Setup
Hysteresis
143 MF2 Setup
Threshold
Velocity
144 MF2 Setup
© SICK AG • Subject to change without notice • 8019720/ZVZ7/2018-03-22
Operating instructions Distance measuring device DL100 – EtherNet/IP
DINT Range: -300 – 300m
UDINT Range: 1mm – 300m
DINT Range: 50mm/s – ...mm/s
USINT Threshold velocity can be exceeded in one or both directions.
- (0)
+ (1)
+/- (2, default)
DINT Preset value that will be applied if attribute 121 is set to
INPUT_PRESET_STATIC.
Range: -300 – 300m
MF2 Configuration
Type
ENUM Active level of MF2. Can either be HIGH (0) or LOW (1).
ENUM Function of MF2. Can be one of:
OUTPUT_DISTANCE_THRESHOLD (0)
MF2 is an output and is toggled when attribute 10 exceeds/falls
under attribute 141/142.
OUTPUT_VELOCITY_THRESHOLD (1)
MF2 is an output and is toggled when attribute 24 exceeds/falls
under attribute 143/144.
OUTPUT_SERVICE
MF2 is an output and is toggled by a logical OR over all active
service attributes 135-140.
BOOL Plausibility Warning and Error
Disabled (0, default), Enabled (1):
If disabled, Error and Warning bits are not considered when
attribute 134 is set to OUTPUT_SERVICE.
BOOL Level Warning and Error
Disabled (0, default), Enabled (1):
If disabled, Error and Warning bits are not considered when
attribute 134 is set to OUTPUT_SERVICE.
BOOL Laser Warning and Error
Disabled (0, default), Enabled (1):
If disabled, Error and Warning bits are not considered when
attribute 134 is set to OUTPUT_SERVICE.
BOOL Temperature Warning and Error
Disabled (0, default), Enabled (1):
If disabled, Error and Warning bits are not considered when
attribute 134 is set to OUTPUT_SERVICE.
BOOL Device not ready
Disabled (0, default), Enabled (1):
If disabled, bit is not considered when attribute 134 is set to
OUTPUT_SERVICE.
BOOL Heater active
Disabled (0, default), Enabled (1):
If disabled, bit is not considered when attribute 134 is set to
OUTPUT_SERVICE.
DINT Range: -300 – 300m
UDINT Range: 1mm – 300m
DINT Range: 50mm/s – ...mm/s
USINT Threshold velocity can be exceeded in one or both directions.
Description
(2)
73