SICK DL100 Pro Notice D'instructions page 71

44/45 Alarms
46 Alarm Flag
47/48 Warnings
49 Warning Flag
51 Offset Value
Vendor specific extension of the Position Sensor Object
Attribute Name
100 Level
101 Temperature
102 Op. Hours
103 Status,
Warning and
Alarm Flags
104 Laser Cntrl.
105 Dynamic Preset
© SICK AG • Subject to change without notice • 8019720/ZVZ7/2018-03-22
Operating instructions Distance measuring device DL100 – EtherNet/IP
1
2..4
5..7
Word Alarms (44) and Supported Alarms (45) of the device.
Bit
0
1
2..11
12
13
14
15
BOOL Logical OR over all Alarms
Word Warnings (47) and Supported Warnings (48) of the device.
Bit
0..10
11..12
13
14
15
BOOL Logical OR over all Warnings
DINT Offset value (read only)
Type
WORD Signal strength in dB
SINT Temperature in °C
WORD Operating hours
Word Status, Warning and Alarm Flags
Bit
0
1
2
3
4
5
6
7
8
9
10
11
ENUM Switch laser on / off.
LASER_ON (0, default)
LASER_OFF(1)
DINT Dynamic Preset, referenced by output assembly 0x80.
Writing 0x800000A presets the distance value to 10. In case
attribute 15 is set to 0x0801 (1/10mm), a value of 10 equals a
preset to 1mm.
Scaling
Reserved by CIP
Always 0
Vendor specific
Name
Position Error Plausib. Error
Diagnostic error
Reserved by CIP
Always 0
Vendor Specific
Vendor Specific
Vendor Specific
Vendor specific Temperature Error
Name
Defined by CIP
Reserved by CIP
Vendor Specific
Vendor Specific
Vendor specific Temperature Warning
Description
Name
Laser Warning
Temp. Warning
Level Warning
Plausib. Warning
Laser Error
Temp. Error
Level Error
Plausib. Error
MF1 active 1 = active
MF2 active 1 = active
Laser 1 = Laser on
0 = Laser off
Heater 0 = Heater off
1 = Heater on
decreasing (1)
off (0)
on (1)
Description Supported
off (0)
on (1)
-
Laser Error
Level Error
Description Supported
Laser Warning
Level Warning
Description Supported
Yes
-
No
Yes
No
-
No
Yes
Yes
Yes
No
-
Yes
Yes
Yes
71