Start-Up; Safety Instructions; Starting-Up Type 8692 - Burkert 8692 Guide Rapide

Type 8692, 8693

13 START-UP

A detailed description of the start-up and operating pro-
cedures can be found at our homepage in the operating
instructions for Type 8692/8693.
13.1 Safety instructions
WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the area around it.
▶ Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
▶ Observe the safety instructions and intended use.
▶ Only adequately trained personnel may start up the equipment/
the device.
Start-up
13.2 Starting-up Type 8692
13.2.1 Specifying the basic settings
The basic settings are made on the setting level.
To switch from the process to the setting level, press the
MENU
key for approx. 3 seconds.
For starting up you must specify the following basic settings:
• Setting the input signal (INPUT)
• Automatic adjustment of the positioner (X.TUNE)
Applies only to process valves that are not pre-assembled:
• Setting of the operating mode for the pneumatic actuator
(ACTUATOR)
The setting of the operating mode (control function A, B or I) in
the ACTUATOR menu, is described in the operating instructions
for Type 8692/8693.
In general, Type 8692/8693 is supplied with a pre-
assembled process valve. In this case the operating mode
of the actuator is already pre-set.
For this reason, the input of the control function (A, B or I) is
not required in case of a pre-assembled process valve.
English
31