Safety End Positions - Burkert 8692 Guide Rapide

Type 8692, 8693
Safetyendpositions
13.3.2 Manually changing the process
set-point value
Procedure:
1. S et the set-point value default on the setting level:
In the main menu (MAIN), select the P.CONTROL function
ENTER SETUP
P.CONTROL
→
EXIT
Use the key (press 4 x) to return to the process level.
2. O n the process level, manually change the process set-point
value:
→
Use the arrow keys
display for the process set-point value (SP).
→
Press the key
INPUT .
→
Insert
SET VALUE
process set-
SP:
point value
[m3/min]
(as shown
on the right-
+
ESC
hand image)
Return
without
change
Fig. 22: Enter values
ENTER
SP-INPUT internal
to select the
SP
m3/min
MENU PV
Enter values:
70.0
Changeable number
070.0
+
Accept set value
<-
OK
Change by one position to the left
Increase number
14 SAFETY END POSITIONS
Actuator
system
SELEC
up
down
30.0
PV (t) INPUT
up
down
up
down
Tab. 15: Safety end positions
Safety end positions after failure
Desig-
of the auxiliary power
nation
electrical
control system for high
air flow rate (DN 2,5):
single-
acting
down
Control
control system for low
function A
air flow rate (DN 0,6):
control system for high
air flow rate (DN 2,5):
single-acting
up
Control
control system for low
function B
air flow rate (DN 0,6):
down / up
(depending
double-
on the
acting
installation
Control
of the
function I
pneumatic
connection)
English
pneumatic
down
not defined
up
not defined
not defined
35