Büs / Canopen Design - Burkert 8681 Guide Rapide

büS / CANopen design
Terminal strip 2 Assignment (external initiator)
L Power supply - conductor
S4 IN External initiator input
N Power supply - neutral conductor
→
Close the housing.
→
Ensure IP protection (dummy plug)
An external initiator can be connected via terminal strip 2 - see
Operating Instructions, chapter "Connecting an external initiator".
Type 8681
12 S / CAN
BÜ OPEN
"büS" is a system bus developed by Bürkert with a communication
protocol based on CANopen. The description of the CANopen
objects (index / subindex) can be found in a separate document
on the Bürkert website (search for: Type / Downloads / Software).
The following explanations refer to the application of the e.g.
EtherNet/IP protocol using a Bürkert gateway preconfigured
for a maximum of 63 control heads.
However, the following bus systems are also supported by the
Bürkert gateway: PROFINET, Modbus/TPC, PROFIBUS DPV1,
EtherCAT, CC-Link.
After the electrical and pneumatic installation of the büS/CANopen
control heads in the network (see chapter "7" and from "12.3"),
perform the following actions on the control heads:
→
Addressing of the control heads (chapter "12.10")
→
Setting the baud rate (chapter "12.10")
→
When using büS/CANopen control heads in conjunction with
a (preconfigured) gateway: "Hiding" of non-existent devices
(chapter "12.5")
→
Sealing of unused connections (chapter "12.6")
For detailed information on the büS/CANopen design, refer to the
Operating Instructions Type 8681.
english
DESIGN
25