Start-Up; Transportation, Storage, Disposal - Burkert 8681 Guide Rapide

15

START-UP

WARNING!
Risk of injury from improper operation!
Improper operation may result in injuries as well as damage to
the device and the area around it.
` Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
` Observe the safety instructions and intended use.
` Only adequately trained personnel may start up the system/
the device.
→
Installation of the control head Type 8681 (see chapter "7" on
page 11).
→
Pneumatic and electrical installation (see chapter "7.3", "7.5")
→
Setting the position measuring system (Teach-In or Autotune)
- see chapter "14"
→
If Type 8681 with bus communication is used: Setting up the
network - see always from chapter "9.2" (AS-i), "10.2" (Devi-
ceNet), "12.4" (büS/CANopen), "13" (IO-Link) .
The control head is ready for operation after assembling, installing
and setting the position measuring system (and the network if
necessary) according to the Operating Instructions Type 8681.
36
english
Type 8681
Start-up
16 TRANSPORTATION, STORAGE,
DISPOSAL
NOTE!
Storage / Transport damage!
Inadequately protected devices may be damaged during trans-
portation or storage.
` Protect the device against moisture and dirt in shock-resistant
packaging during transportation/storage.
` Prevent the temperature from exceeding or dropping below the
permitted storage temperature.
` Storage temperature: -20 ... +65 °C.
NOTE!
Damage to the environment caused by device components
contaminated with media.
` Observe applicable disposal and environmental regulations.
→
Dispose of the device and packaging in an environmentally
friendly manner.
→
Observe national waste disposal regulations.