Component Review - Dibo JMB-M Mode D'emploi

E N
O P E R AT I O N
1 emergency stop
2 key contact
3 throttle lever (when used)
4 control stick
5 display
1
2

COMPONENT REVIEW

1 F U E L M OTO R
The type depends on the type of cleaner: see "Technical data" on page 41 .
2 P R E S S U R E I N D I C AT I O N
On the display you can read the pressure.
3 B U R N E R
The type of burner depends on the type of cleaner. The 'green burner' is a
burner that makes a higher efficiency. The burner provides hot water.
The temperature of the water is adjustable. The burner is double- walled.
The outside wall is air cooled by the ventilator lateral on the burner chamber.
On top of the burner one can find the burner mouth. The water supply and
outlet are both situated at the bottom of the burner.
Lime scale deposits while working at higher temperatures
The hardness of the water is possible expressed in French degrees (°F) or
German degrees (°D). The difference is noticeable in the following equation:
1 ° F = 0.56 ° D. For example, water having a hardness of 40 ° F has a German
hardness of 40 x 0.56 = 22.4 ° D.
See the in your area prescribed hardness of drinking water. Hard water can
cause problems by means of lime scale from 30°F or 17°D. When hardened
water is now warmed / heated / or being pumped (or when hard water comes
in contact with air), this can cause calcification. Hard water is caused mainly by
the presence of two components: calcium and magnesium. So the harder the
water, the more chances on lime scale! When cleaning with high temperatures
(or at using heated water) , you obtain thus faster calcification in case of a low
hardness! This can therefore result in loss of energy efficiency, higher energy
consumption and reduced capacity of water supply (including calcium deposits
on the burner coil and other water connection parts).
We, DIBO NV, therefore recommend to decalcify the machines with a burner
preventive additionally and after use of hot water rinse adequate with cold
water (if possible) to ensure optimum performance of the machine!
4 H I G H P R E S S U R E P U M P
The type depends on the type of cleaner: see "Technical data" on page 41 .
5 T R A I L E R ( N OT W I T H A B U I LT- I N V E R S I O N )
The machine is built on a trailer. Place the trailer horizontally on a stable surface
during spraying activities, this to avoid for a possible failure from draining of the
water tank.
6 WAT E R TA N K
The water tank is an reservoir that is assembled between the water system (tap)
and the high pressure pump. The water tank prevents that there may appear
pressure impulses in the water system. Pressure impulses appears by switching
on and off the spray jet. The water tank prevents under all circumstances that
DiBO 16
4
3
5