Dibo JMB-M Mode D'emploi page 108

E N
S A F E T Y – G E N E R A L WA R N I N G S
• Hand brake (braked trailer version):
Pay attention to risk of accident due to failure of the hand brake! If the trailer
is to be uncoupled from the towing vehicle, the hand brake must be applied
and the trailer must be secured by means of two additional wheel blocks. At
parking or placing of the whole combination, tighten also the hand brake!
Danger - risk of injury! The trailer may roll back before the full braking force is
applied! Ensure that there is sufficient space when parking the trailer.
• Breakaway cable (@ braked trailer):
Always route the breakaway cable through the breakaway cable guide ring!
See photo beneath. Attach the breakaway cable in such a way that cornering
is not impeded. The breakaway cable must not be wrapped around the jockey
wheel.
Observe country specific regulations when attaching the breakaway cable.
Danger due to uncoupling of the trailer!
• Jockey wheel / support arm:
Ensure that the jockey wheel is seated securely and that the support arm is
secured, before driving on the road!
Working with steam (if applicable):
There is a risk on burning injuries at operating temperatures above 98 °C! Never
touch the steam jet! Please note that some materials can cause stresses when
you clean these surfaces with steam (eg: risk of glass breakage at cleaning
of glass surface), Always steam gently the surface to be cleaned at first use!
Always provide sufficient personal protective equipment whenever you work
with steam!
Use the appropriate spray equipment!
Tarpaulin (option - if applicable):
Use the tarpaulin only when transporting the trailer or when the cleaner will
NOT be used! At spraying activities: remove & loosen the tarpaulin (this because
of sufficient ventilation (air duct) and operating/ visibility of the control panel)!
Durability of the machine:
The durability of your cleaner will be determined / is dependent on the care
& maintenance interventions you spend on the cleaner. The instructions,
information and suggestions in this manual (and all delivered documentation)
are for this purpose a guide to guarantee optimal service life (durability).
Avoiding the hazards, possible repairs, failures of the cleaner, will improve
the reliability of the machine. Regularly performing a maintenance procedure
moreover extends the durability of a machine.
Risk analysis:
On the machine a risk analysis has been carried out. The risk analysis focuses
on mapping the most important risks that may occur during use and / or
maintenance and the measures that have been taken to exclude or minimize
the risk. The safety rules can be followed to limit these risks. Please note; the
machine is constructed in such a way to avoid dangerous situations as much
as possible, but a totally risk-free machine is not possible. There are always
residual risks present. Therefore, read all (safety) instructions in this chapter
carefully and inform yourself if there are any uncertainties.
Maintenance:
Electromechanical, pneumatic and hydraulic work must always be carried out
by persons with expertise in relation to this specific work. Always inform the
different operators before starting any special and / or maintenance work.
Always follow the maintenance and / or inspection activities as described in
this manual. The periodic checks and the replacement of parts must also be
followed as described. We advise that new people are instructed about the
possible dangers, as well as the prevention of the various dangers.
DiBO 12