Component Review - Dibo JMB-C+ Serie Mode D'emploi

E N
O P E R AT I O N
1 display
2 control stick
3 key contact
4 key remote control
5 emergency stop

COMPONENT REVIEW

1 F U E L M OTO R
The type of fuel motor depends on the type of cleaner (see "Technical data" on
page 40 ).
2 P R E S S U R E I N D I C AT I O N
On the display you can read the pressure.
3 B U R N E R
The type of burner depends on the type of cleaner. The 'green burner' is a
burner that makes a higher efficiency. The burner provides hot water.
The temperature of the water is adjustable. The burner is double- walled.
The outside wall is air cooled by the ventilator lateral on the burner chamber.
On top of the burner one can find the burner mouth.
The water supply and outlet are both situated at the bottom of the burner.
Lime scale deposits while working at higher temperatures
The hardness of the water is possible expressed in French degrees (°F) or
German degrees (°D). The difference is noticeable in the following equation:
1 ° F = 0.56 ° D. For example, water having a hardness of 40 ° F has a German
hardness of 40 x 0.56 = 22.4 ° D. See the in your area prescribed hardness of
drinking water. Hard water can cause problems by means of lime scale from
30°F or 17°D.
When hardened water is now warmed / heated / or being pumped (or when
hard water comes in contact with air), this can cause calcification. Hard water is
caused mainly by the presence of two components: calcium and magnesium.
So the harder the water, the more chances on lime scale! When cleaning
with high temperatures (or at using heated water) , you obtain thus faster
calcification in case of a low hardness! This can therefore result in loss of energy
efficiency, higher energy consumption and reduced capacity of water supply
(including calcium deposits on the burner coil and other water connection parts).
We, DIBO NV, therefore recommend to decalcify the machines with a burner
preventive additionally and after use of hot water rinse adequate with cold
water (if possible) to ensure optimum performance of the machine!
4 H I G H P R E S S U R E P U M P
The type of high pressure pump depends on the type of cleaner
(see "Technical data" on page 40 ).
5 T R A I L E R ( N OT W I T H A B U I LT- I N V E R S I O N )
The machine is built on a trailer. Place the trailer horizontally on a stable surface
during spraying activities, this to avoid for a possible failure from draining of
DiBO 16
1
2 4
3
5