Control Of Oil Level And Refreshing Pump Oil; Control Of Oil Level And Refreshing Reduction Gearbox Oil; Cleaning Of The Water Filters; Cleaning Fuel Tank + Oil And Fuel Filters - Dibo JMB-M Mode D'emploi

1 fuel filter
2 oil filter
3

Control of oil level and refreshing pump oil

Check for each use of the machine, the oil with the oil level glass or with the oil
level bar. Oil must stand right with the sign of the oil level glass, if this is not, oil
tops up until the sign. If oil looks milky, consult directly the DiBO technicians.
To refresh oil, work as follows:
• Unbolt the drain plug below the pump.
• Unbolt the tap with the oil level bar.
• Catch all oil in a barge and remove oil like further described in the guide.
• Force up the drain plug there and top up the oil in the breach to the upper
part to on the mark line.
• Force up the tap with the oil level bar there.
• Recommended oil: 1.836.042 (+- 1Ltr, depending the pump).
4

Control of oil level and refreshing reduction gearbox oil

Check for each use of the machine, the oil with the oil level glass. Oil must stand
right with the sign of the oil level glass, if not the case, refill the oil up to the
mark sign. If oil looks milky, consult directly the DiBO technicians.
To refresh oil, work as follows:
• Unbolt the drain plug below the reduction gearbox.
• Catch all oil in a barge and drain the dirty oil in an environmental friendly way.
• Tighten the drain plug (with new seal ring) and top up the oil to the upper part
till the mark line.
• Recommended oil: 1.836.015 (0.35 Ltr).
5 Cleaning of the water filters
Clean the filter cartridge (60 μ) of the water filter and strainer (3/4") regularly,
remove possible dirt. Before dismantling the bowl (cartridge filter) you should
first release the pressure, next clean the filter. Replace the filter cartridge filter
and every damaged parts (O-ring, ...) if necessary to ensure good performance
under pressure and water- tightness of the whole filter. Loosen the filter at the
bottom of the trailer (at the height of the position light) simply and clean it. If
necessary, you can replace the sieve.
6 Cleaning fuel tank + oil and fuel filters
The oil- and fuel filters defuse and cleaning, possibly replace. Empty the fuel
tank. Remove the drain plug and catch possible dirt in a can. Rinse and clean
the tank with a little bit off clean fuel and close the drain plug.
1
7

Maintenance engine general

For maintenance activities to the engine we advise to consult also the supplied
instructions for engine use. Recommended oil: 1.836.005 (200/18: 2.5Ltr -
200/30 & 350/18: 3.8Ltr - 500/15: 5.2Ltr). The engine has a drain tap at the
bottom to drain the used fuel.
8

Oil drain engine

Remove the black drain plug of the engine block (engine will leak no oil by the
drain spring in the nipple). Couple the drain hose to the engine block nipple
(see picture), the drain spring will now be pushed and the oil flows through the
flexible hose. Remove the plastic cap at the end of the hose and drain all used
oil in a drip pan. Replace the oil filter if necessary (see manual). Push the drain
plug again in the engine block (end of oil maintenance). Attention: remove the
dirty oil from the drip pan on environmental friendly method.
DiBO 33
E N
S E R V I C E
2