Dibo JMB-M Mode D'emploi page 106

E N
S A F E T Y – G E N E R A L WA R N I N G S
Machine:
Never take the machine in use without water. Even a brief lack of water can
lead to serious damages! When the machine is connected to the drinking
water supply, the existing regulations about that must be observed (EN 1717).
The machine must stand on a stable horizontal base with the brake on! Work
at artificial light: if daylight offers not sufficient visibility during the use, the use
of adapted impermeable lighting armature + stretches to recommendation. In
spaces provide with standard lighting these must remain on wide distance of
the water jet. Never work during adverse weather conditions (eg storm, rain, ...)
in the open air. The machine at filling station or in other danger areas because
of the explosion danger, which can assume the burner, only uses outside the
determined danger area. Fixed adjustments of the machine can be modified
under no circumstances himself. The high pressure cleaner has been made
in running order and tested by DiBO according to the safety standards. Never
solvent holding fluids such as petrol, oil or dilution suck in, the arisen spray veil
can be extremely inflammable and/or toxic. When the machine is in use these
can never be left behind unattended. Pay attention to sufficient ventilation.
Machine does not cover or use in spaces with insufficient ventilation! Vehicle
tyres/tyre valves may be cleaned only with a minimum spray distance of 30 cm.
Otherwise, the high pressure spray can cause damage to the vehicle tyre/tyre
valve. The discolouring of the tyre is the first sign of damage. Damaged vehicle
tyres are a source of danger. Do not spray materials containing asbestos or
other health hazardous substances.
Water exit:
See for a sound and smooth water outlet of the effluent. If there is cleaned
with detrimental chemicals or when the object to clean is strongly polluted, the
effluent must be purified before draining this in the sewer.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Usage of different products (cleaning product,
softener, decalcifier,...) (when applicable):
Avoid adding chemicals or cleaning detergents to the water tank. Read
always firstly the regulations on the packing of the product. Never clean with
inflammable products. See for separate care/cleaning of evacuation water.
See for the necessary personal protective equipment (glove, clothing, optical
device...). Avoid spilling from a product. Put the product tank directly beside
the machine. Remove the filling cap and hang the supply hose in the tank. Care
always for a ventilated hole in the filling cap! Take care that the tank is always
protected sufficiently against the used medium.
Softener:
Special fluid for soften of hard and very hard water. Application of this product
reduced considerably fastening on floating lime - and iron chloride parts on
heating spirals, piping, sprinkler heads etc. of heating equipment, high pressure
- and steam cleaners, etc.. A continuous use will extend the durability of the
machine considerably and improve simultaneously the output strongly.Use
the DiBO softener (1.837.001/3.8550.650) , contact DiBO for more info. Good
softeners are:
• Biologically degradable
• PH between 6-9
• NOT inflammable
Traffic:
Protect piping and cables which run over a roadway with dock boards.
Personal safety measures:
Do not move the machine during operation. Avoid a bad body posture. Consult
immediately a doctor at skin penetration and definitely state the type of used
product.
DiBO 10