Activation; Set To Work - Dibo JMB-M Mode D'emploi

28 P R O F E S S I O N A L S W I TC H M O D E B AT T E RY C H A R G E R ( O P T I O N )
The trailer with track & trace will be standard equipped with a charging cable
(1.701.075) to connect any professional switch mode battery charger (1.701.210)
on the battery.
Pay attention: the battery may not be charged constantly!
The trailer (machine) may not be switched on at any
circumstances during the charging procedure!
For info: If the battery clamps are incorrectly connected, the reverse polarity
protection will ensure that the battery and charger are not damaged.
Estimated time for charging (for an empty battery): +- 20h. The charger is
designed for charging only for batteries according to the technical specification.
See also the delivered manual of the professional switch mode battery charger.
29 T E M P E R AT U R E C O N T R O L L E R ( O P T I O N A L )
The temperature controller ensures that the output temperature remains
constant, regardless fluctuations in the temperature of the supplied water
(within the limits of the system). This system also ensures optimum load of the
burner, which benefits the emissions and lifespan of the burner (less circuitry).
Also the water heating at cold start will work out faster.
30 D E S C A L I N G C O I L ( O P T I O N A L )
The descaling coil is an additional accessory and is located around the high-
pressure hose at the entrance to the burner boiler. This coil need to prevent
possible lime formation in the supply hose and in the burner coil.
The coil gives a signal that changes the shape of the lime minerals in the water.
As a result, small groups are formed that can no longer attach themselves to the
components and will therefore flush out of the pipes/hoses. This coil extends
the service life of the components exposed to limescale deposits.

Activation

SET TO WORK

Turn the key contact to position 1 (=ON) and wait till the lamp of preheating is
extinguished, then turn the key contact further to position 2 (=START) to start
the fuel engine. Leave the key when the fuel engine is started. The automatic
speed control option has a fixed setting on 50 % (or place the throttle lever at
position 1/2, depending the selected option). When the fuel engine is running,
allow the engine to warm up at stationary revolutions. Point the spray gun in to
the open space and operate the spray gun until the water supply is completely
de aerated. Operate the spray gun and adjust if necessary the spray pressure
by operating the throttle lever/control stick. For the use of hot water, set the
temperature on desired value through the control stick and by following the
instructions of the temperature menu on the display.
After turning 30 minutes into bypass, the cleaner will switch off and an
indictaion will be visualized on the display.
Make sure that the valve is on 'high temperature function' and the throttle
is on position 'high temperature function', when you want to work with high
temperatures (standard configuration)! Use the appropriate spray equipment!
DiBO 21
E N
AC T I VAT I O N