Service; General; Maintenance Diagram General; Periodic Maintenance - Dibo JMB-M Mode D'emploi

E N
S E R V I C E

Service

GENERAL

All maintenance activities must happen at an disconnected machine and
hoses without pressure. Allow to cool down the cleaner before performing
maintenance activities! Checking the electric components can happen
exclusively by an expert. Exclusively accessories and replacement components
which have been approved by the manufacturer can be used. Directly after
the activities all securities- and protection parts must be assembled, before
the machine is put in functioning. "a golden rule" that contributes to a perfectly
working machine with few problems, is the following:
A daily control and cleaning of the machine frequently do wonders!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly
at regular times with a thorough maintenance. Therefore the experience and
the "know-how" of DiBO a technical good working machine is insured and large
maintenance turns can be carried out by experienced DiBO technicians by
means of appointment or maintenance contract, we can suppose in advance
that it is satisfied to these two points.
MAINTENANCE DIAGRAM
1 General
Check daily by means of the maintenance diagram the high pressure cleaner.
You find the maintenance diagram on the following pages. Check even all
transmission belts on good tension and possible defects. If not, then consult the
proper maintenance technicians.
PAY ATTENTION: Take care that the transmission belts are not in
movement and observe the applying safety standards! Always secure
the trailer with wheel blocks before starting any maintenance works!
2

Periodic maintenance

DESCRIPTION
Check the electric cables, high & low pressure ho-
ses, couplings and control of the oil level. Check
the wheel bolts/ Ball clutch/plug/lights/brakes/
good tyre pressure of the trailer
Refreshing pump oil
Refreshing reduction gearbox oil
Cleaning water filter(s)
Replacement and cleaning oil filters and fuel
Cleaning fuel tank
Change the alternator belt
• All following refreshments of pump oil and re-
duction gearbox oil.
• Cleaning of the heat exchanger (depending fluid
properties and calcium deposits).
• Replace the bypass valve(s).
Refreshing engine oil, maintenance engine
Extra control/replacement of joints, valves, o-
rings by acknowledged technicians
• Lubricate or oil all sliding or jointed parts of the
overrun device
• Check on possible wear of the wheel brakes/
bearings/brake lining.
• Replace the coolant of the engine.
DiBO 32
filters
PERIOD
After each use
First 50 hours
First 50 hours
First 50 hours
First 50 uur, every next
250 hours
First 50 uur, every next
250 hours
Every 500 hours. Yearly.
Every 250 hours
See enclosed motor
instruction manual
Every 750 hours
Yearly