Control Screen 2 (Temperature Setting); Control Screen 3 (Engine Speed Setting - Optional); Control Screen 4 (Lighting - Optional); Control Screen 5 (Filling Pump - Optional) - Dibo JMB-M Mode D'emploi

6

Control Screen 2 (Temperature setting)

In this screen you can set the desired burner temperature. Move the control
stick upwards (raise temperature) or downwards (lower temperature) to set the
desired temperature. Increase/decrease can be done in steps of 5 °C. Turn off
the burner immediately: Move the control stick quickly up / down. Minimum
value 0 °C - Maximum set point: depending on the factory setting. Operate to
the left: return to the main screen (at each other screen, same principle).
Operate to the right: navigate to the next operation menu (at each other screen,
same principle). At the top right, the current temperature is visualized and at the
top left the burner indication.
7

Control Screen 3 (Engine speed setting - optional)

In this screen you can set the desired engine speed. The basic setting at
the start is set at 50%. Move the control stick upwards (increase speed) or
downwards (lower speed) below to set the desired engine speed. Increase/
decrease in steps of 10%. Minimum value 0% - maximum value 100%.
At the top right, the current pressure is visualized.
Pay attention: If the key contact is put into position "ON" , the engine
speed is not adjustable. Start the key contact by before the engine
speed is adjustable!
8

Control Screen 4 (Lighting - optional)

In this screen you can set the lighting. Move the control stick upwards (work
light on/off) or downwards (beacon light on/off) to set the desired condition.
Push the control stick to activate, push again to deactivate.
9

Control Screen 5 (Filling pump - optional)

In this screen you can turn on / off the filling pump.
Move the control stick upwards (turn on) or downwards (turn off).
DiBO 25
.
E N
AC T I VAT I O N