Boston Scientific Vercise DBS Mode D'emploi page 45

2
If desired, check Set as Patient Defaults to save settings to the Remote Control as defaults.
Note: If the Set as Patient Defaults is checked, these program settings will be used for all
future programs created for the current patient.
3 Click to save your changes or
Setting Program Options as Patient Defaults
The Set as Patient Defaults option allows you to use the current program settings (Cycle, Ramp
Up, and Lockout Remote Amplitude) for all new programs created for the current patient.
1 Check or uncheck the box next to the Set as Program Defaults option.
2
Click to save your changes or
The Lockout Remote Amplitude option is activated. The
patient cannot change the stimulation amplitude using the
Remote Control.
The Lockout Remote Amplitude option is deactivated. The
patient is able to change the stimulation amplitude using
the Remote Control.
The current program options will be used for all future
programs created for the current patient.
The default program options will be used for all future
programs created for the current patient.
Programming the Patient
to exit without saving.
to exit without saving.
Vercise™ DBS Programming Manual
91053785-07 39 of 323