External Switching Commands; Input For External On/Off; Bus Signal - Biral HP-E Instructions D'installation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

english

8. External switching commands

The pump has inputs for the following external
switching commands:
– External ON/OFF
– Digital function

8.1 Input for external ON/OFF

Function diagram: input for external ON/OFF
External ON/OFF (terminals 2 and 3)
H
Q
H
Function diagram: input for digital function:
Digital function
(terminals 1 and 9 – single-phase pumps)
(terminals 1 and 3 – three-phase pumps)
H
H
H
48
Normal operation
Normalbetrieb
Stop
Stop
Q
Normal operation
Normalbetrieb
Q
MIN characteristic
MIN-Kennlinie
curve
Q
MAX characteristic
MAX-Kennlinie
curve
Q

9. BUS signal

The pump provides serial communication via an RS-485
interface. Communication is according to the GENIbus
protocol, and permits connection to a GLT or similar
system. (Possible types of control on request)
With the BUS signal it is possible to set pump operating
parameters such as reference value, mode of operation,
etc. from a remote point. At the same time the pump can
supply status information via the BUS for important
parameters, such as actual value of control parameter,
power consumption, fault indications, etc.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hpc-e

Table des Matières