Overview Of Angle Brackets With Measurement Specifications And Identification Numbers For All Vehicles; Check Coarse-Threaded Bolt Is Fitted In All Vehicles; Prepare Underside Panelling In All Vehicles For Installation - BMW F 36 82 1265 R Mode D'emploi

10. Overview of angle brackets with measurement specifications and
identification numbers for all vehicles
F 36 82 1220 R
Overview angle brackets
Identification no.
3
5
9
11
13
15
16
17
18
22
23
Overview flat bars
Identification no. Drillhole
28
29
Overview clamps
Identification no. Drillhole
34
Angle bracket for mounting the control unit
Identification no. Drillhole
17
11. Check coarse-threaded bolt
is fitted in all vehicles
All vehicles except for M roadster and vehicles
with underside panelling
F 36 82 1202 R
In all vehicles a check must be made to see if the
coarse-threaded bolt (1) is present at the left
engine support (2). If no coarse-threaded bolt is
fitted, a drillhole ø 6.5 mm will have to be made in
accordance with measurement specifications a
and b at the left engine support (2).
Deburr the drillhole, prime it and paint it (observe
BMW specifications for corrosion protection).
If the coarse-threaded bolt of the right engine
support for fastening the high-voltage
wires/underside panelling is required, the
procedure described above will have to be carried
out in mirror image on the right engine support.
Dimensions: a = 20 mm
b =160 mm
30
Drillhole Leg length to
ø hole centre (a)
6 mm 19 mm
6 mm 33 mm
6 mm 33 mm
6 mm 33 mm
6 mm 40 mm
6 mm 40 mm
6 mm 53 mm
8 mm 53 mm
6 mm 53 mm
8 mm 69 mm
6 mm 69 mm
Leg length to
ø hole centre (a)
8 mm 37 mm
6 mm 37 mm
Mounting cross-section
ø
6 mm
Leg length to
ø hole centre (a)
8 mm 53 mm
Leg length to
hole centre (b)
19 mm
16 mm
33 mm
33 mm
20 mm
33 mm
18 mm
18 mm
18 mm
15 mm
54 mm
Drillhole
ø
6 mm
6 mm
14
Leg length to
hole centre (b)
18 mm
For later fitting of the high-voltage wires in
vehicles without coarse-threaded bolt, the plastic
expanding rivet is used for attachment.
12. Prepare underside panelling in
all vehicles for installation
Only vehicles with M44 engine and manual
gearbox from 09.96
F 36 82 1285 R
Hold the enclosed drilling template (4) against the
lower part of the underside panelling, adjust it and
transfer drillholes with a marking pen.
Mark measurements a, b, c and d with a marking
pen.
Make all drillholes in the underside panelling (5)
with a twist drill ø 5.5 mm.
Drillhole 2nd drillhole
ø ø
6 mm –––––
6 mm –––––
6 mm 6 mm
8 mm –––––
6 mm –––––
6 mm –––––
6 mm –––––
6 mm –––––
8 mm –––––
6 mm –––––
8 mm –––––
Drillhole
ø
6 mm
Leg length to
hole centre (c)
–––––
–––––
16 mm
–––––
–––––
–––––
–––––
–––––
–––––
–––––
–––––