Access By Name With A Drop-Down Menu - DAB E.SYBOX MINI 3 Instructions Pour L'installation Et L'entretien

4.2 - Access by name with a drop-down menu

The selection of the various menus is accessed by name. From the main menu you access
menu selection by pressing either of the ˄ or ˅ keys.
The names of the menus that can be accessed appear on the menu selection page and
one of the menus is highlighted by a bar (see Figure 13-14). Shift the highlighting bar using
the ˄ and ˅ keys to select the menu you want and enter it by pressing MODE.
Figure 13: Selection of the drop-down menus
The items available are MAIN, USER, MONITOR, followed by a fourth item, EXTENDED
MENU; this item allows the number of menus displayed to be extended. When EXTENDED
MENU is selected a pop-up appears asking you to type in an access key (PASSWORD).
The access key (PASSWORD) coincides with the combination of keys used for direct ac-
cess (as in Table 8) and allows the extended display of the menus from the menu corre-
sponding to the access key to all those with a lower priority.
The order of the menus is: User, Manual Setpoint, Manual, Installer, Technical Assistance.
When an access key is selected, the menus released remain available for 15 minutes or
until they are disabled manually by means of the item "Hide forward menus" which appears
on the menu selection when using an access key.
Figure 14 shows an operating diagram for selecting the menus.
The menus are in the centre of the page, from the right you reach them by means of direct
selection with a combination of keys, while from the left you reach them by means of the
selection system with drop-down menu.
Figure 14: Diagram of possible menu accesses
4.3 - Structure of the menu pages
When switched on, some presentation pages are displayed showing the name of the prod-
uct and the logo, after which the main menu appears. The name of each menu, whichever
it may be, is always at the top of the display.
The following always appear on the main page
Status: operating status (e.g. standby, go, Fault)
Revs per minute: value in [rpm]
Pressure: value in [bar] or [psi] depending on the set unit of measure.
Power: value in [kW] of the power absorbed by the device.
GB
ENGLISH
52