Installation Procedure; Mounting Location; Mounting Holes - BRP EVINRUDE ICON 764909 Mode D'emploi

INSTALLATION PROCEDURE

Refer to the ICON System Quick Connection
Guide, P/N 764953 for ICON System Diagram.
Disconnect the battery cables at the battery.
Test remote control operation after installation is
complete.
WARNING
Failure to properly install and test remote
control operation may result in remote
control malfunction and the loss of boat
control.

Mounting Location

Select an appropriate location based on the boat
configuration.
1
1. Side console
2. Center console
IMPORTANT: The mounting location must be a
flat surface and must be strong enough to pro-
vide rigid support. Strengthen mounting surface
as necessary.
Refer to ICON SINGLE BINNACLE REMOTE
CONTROL PROFILE DRAWING on page 14
and ICON DUAL LEVER BINNACLE REMOTE
CONTROL PROFILE DRAWING on page 15
Place remote control at proposed location and
check clearance around remote control lever at
full throttle in FORWARD and then at full throttle
in REVERSE. There must be at least 2.5 in. (64
mm) of clearance between the handle and any
2
005471
part of the boat throughout the control lever
travel.
85.5°
2.5 in (64 mm)
There must be at least 5 in. (127 mm) of clear
space below the control for the housing and
network cable routing.

Mounting Holes

Refer to ICON SINGLE BINNACLE REMOTE
CONTROL - DRILL TEMPLATE on page 17 and
ICON DUAL LEVER BINNACLE REMOTE
CONTROL - DRILL TEMPLATE on page 19.
Use appropriate drill template to cut mounting
holes.
IMPORTANT: Make sure the mounting location
has all the required clearances before drilling or
cutting.
Protect mounting surfaces from damage while
drilling. Apply masking tape to fiberglass
surfaces. Use appropriate protection for other
surfaces.
1. Masking tape
FWD
NEUTRAL
15.0°
15.0°
REV
40.5°
007920
1
007921
5 of 20