BRP EVINRUDE ICON 764909 Mode D'emploi page 12

Second or Remote Station
Push clip of emergency stop lanyard onto
emergency stop switch. Restart outboard(s).
1. Clip of emergency stop lanyard
1. Clip of emergency stop lanyard
With outboard(s) running remove emergency
stop lanyard from second station emergency
stop switch. Outboard(s) must STOP. If outboard
does not stop, check emergency stop switch and
wiring. Repair as needed.
On Water Test
Secure boat to dock to prevent motion. Snap the
emergency stop lanyard to a secure place on the
operators clothing or life vest – not where it might
tear away instead of activating the stop switch.
12 of 20
Push clip of emergency stop lanyard onto master
power switch.
1
RUN
OFF
2
1. Clip
2. Master power switch
007897
WARNING
1
Lanyard MUST be securely attached to
operator, and clip MUST be installed on
master power switch. DO NOT operate
outboard with clip removed from switch,
except in an emergency.
Refer to the ICON User's Guide for remote
control operation.
007898
Position control lever(s) in the NEUTRAL
position to start or stop outboard.
Turn master power/key switch to RUN position.
Press START symbol of START/STOP switch.
Release switch as soon as outboard starts.
Check shift operation. Check that outboard shifts
into FORWARD gear when control is shifted to
FORWARD, and shifts to REVERSE gear when
control is shifted to REVERSE.
1
005499A