BRP EVINRUDE ICON 764909 Mode D'emploi page 6

Position template. Use center punch to mark the
centers of drill locations.
1. Template
Single Lever Binnacle Mount Controls
Drill three (3) 1/4 in. (6.3 mm) holes at the three
mounting stud locations.
1. Three mounting stud locations
Use a 3 in (76 mm) hole saw to cut out for the
control base.
1. 3-inch hole saw
6 of 20
Dual Lever Binnacle Mount Controls
Drill four (4) 1/4 in. (6.3 mm) holes at the four
mounting stud locations.
1
007922
1. Four mounting stud locations
Use a 3-1/8 in (79 mm) hole saw to cut out for the
control base.
1
007923 1. 3 1/8-inch hole saw
Mounting Control
Install control on console.
1
007933
1
1
007934
1
007924
007925