BRP EVINRUDE ICON 764909 Mode D'emploi page 7

From under console, install washers and #10
locknuts on studs of control. Tighten locknuts to
a torque of 24 to 36 in. lbs. (2.7 to 4 N·m).
1. Locknuts
IMPORTANT: Make sure remote control as-
sembly is secured to console and does not move
during operation.
ICON Network Buss Cables
ICON network buss cables use a proprietary
6-pin threaded, Molex-type connector.
1. ICON buss cable connectors
IMPORTANT: Do not force connectors or lock-
ing rings. Properly aligned connectors should as-
semble easily.
Do not use Electrical Grease on ICON buss
cable connectors.
Align the tabs of the buss cable connectors.
Carefully push connectors together and tighten
locking rings finger tight.
1
1. Large tabs
2. Small tabs
007926
ICON Remote Control Connection
Connect remote control buss cable to ICON
network hub.
If the installation requires a buss cable
extension, use no more than one extension.
1
1. Remote control buss cable connector
2. ICON network hub
Check operation and movement of control
007882
levers. Make sure remote control shift and
throttle functions operate smoothly. Refer to
REMOTE CONTROL OPERATION TESTS on
page 11.
1
2
007883
007884
7 of 20
2