Scope Of Delivery; General Information; Reading And Storing The Operating Instructions; Key To Symbols - Meister MFW300 Manuel D'utilisation

1 – Scope of delivery
1 Clamping protection
2 Tensioning lever
3 On/Off switch
4 Vibration frequency preselection
5 Thread (for handle), 2×
6 Tool holder
7 Plunge cut saw blade
8 Segment saw blade
9 Sanding disc
10 Sanding sheet
11 Handle
12 Extraction adapter
13 Extraction duct
14 Retaining clip
2 – General information
Reading and storing the operating
instructions
These operating instructions
belong to this electric multi-tool
(hereinafter referred to as „mul-
ti-tool"). They contain important informa-
tion regarding safety, use and care.
Read the operating instructions carefully
before using the multi-tool. Pay special
attention to the safety information and
warnings. Failure to follow the operating
instructions in this instruction manual
may result in serious injury or damage to
the multi-tool.
Comply with any applicable local or
national regulations regarding the use
of this product. Store these operating
instructions in a safe place for reference.
When giving the multi-tool to a third
party, be sure to include these operating
instructions.
5454380-Multifunktionswerkzeug-man.indd 61 5454380-Multifunktionswerkzeug-man.indd 61

Key to symbols

The following symbols and signal words
are used in these operating instructions,
on the multi-tool or on the packaging.
Declaration of conformity (see
chapter 'Declaration of con-
formity'): products labelled
with this symbol meet all the applicable
Community Directives of the European
Economic Community.
The TÜV Rheinland seal con-
firms that the multi-tool is safe
when used as intended. The
symbol "GS" stands for tested safety
Products that are labelled with this sym-
bol conform to the requirements of the
German Product Safety Law (ProdSG).
Do not dispose of with
domestic waste!
Read the operating instruc-
tions.
Wear protective goggles.
Wear a dust protection mask.
Wear ear defenders.
Wear suitable protective
gloves.
Products that are marked with
this symbol conform to Safety
Class II.
BJ Year of construction
SN: Serial number
SN: XXXXX The first two underlined
numbers give the month of
manufacture.
61
08.03.21 11:20 08.03.21 11:20