Installation And Setting; Operation; Mode Of Operation - Meister MTS710-1 Mode D'emploi

MW-5451520-Bedien-1610 05.10.16 08:31 Seite 34
Voluntary "geprüfte Sicherheit"
seal of quality (tested safety)
CE mark (conformity with
European safety standards)
7 – Installation and setting
Changing tools
Unplug from the power source. To
change the screw bit, turn the depth
stop (7) back and reset after the tool
has been changed.
8 – Operation
Starting
Press switch (3). The motor will start at
a low speed. The speed will increase as
the pressure on the switch is increased,
until maximum preset speed is reached.
Stopping
Release switch.
Switching on continuous operation
Press the switch (3) down, press the
locking switch (2) and release all
switches.
Switching off continuous operation
Press the switch (3), the locking switch (2)
releases automatically. Release the
switch (3), the machine switches off.
CAUTION! The screwdriver shaft
or inserted screwdriving tool will
not start running until it is pressed
against the work and will stop running
34
as soon as the screwing operation is
finished. As long the screwdriving
tool is not in contact with the material,
it is normal for it to stop running,
even if the motor is still running.
9 – Mode of operation
Preselecting speed
Stop motor. For higher
speed, turn switch (4)
towards (+); for lower
speed, turn it towards (–
). In this way speeds can
be preset to suit material
and screw size. The right speed can be
found by trial and error. It is reached if
the screw can be driven into the work
without overheating.
Forward/reverse rotation
To screw in: set switch to
position R
To unscrew: set switch to
position L
Do not operate forward/
reverse switch while the
motor is running.
Setting the depth stop/working
In order to precisely set
the screw depth, to
prevent damaging
material surfaces to be
screw-connected, pull
the setting ring (8)
forwards as far as it will go. Set the
screw depth by turning the setting ring.
• Turn towards (+): Increases the screw
depth
• Turn towards (–): Decreases the screw
depth
The screw depth is modified by 2 mm for
every complete turn. Pull the setting ring
back to the latching position. The desired