Transmission Signal - Oregon Scientific SMARTHEART SE190 Mode D'emploi

NOTE If the watch is kept idle without receiving a heart
rate signal for 5 minutes, the heart rate receiver will
turn off.
WATCH
You can wear the receiver watch on your wrist or strap
it to a bike or exercise machine. Please note that you
may have to place some foam between the watch and
the bike handlebar to get a secure fit.

TRANSMISSION SIGNAL

The heart rate chest belt and watch have a maximum
transmission range of about 62.5 centimeters (25
inches). flashes when the watch is receiving a signal
from the chest belt.
In the event that you experience a weak signal (i.e.,
SE190_M_EN_R3 6
the watch heart rate monitor will only show "0") or your
signal is disrupted by interference in the environment,
follow the instructions below to identify and resolve the
situation:
• Shorten the distance between the heart rate chest
belt and watch.
• Re-adjust the position of the heart rate chest belt.
• Check the conductive pads are moist enough to
ensure solid contact.
• Check the batteries. Low or exhausted batteries
may adversely affect transmission range.
WARNING Signal interference may cause an incorrect
or unstable heart reading to display. Signal interference
in the environment can be due to electromagnetic
disturbances. These may occur near high voltage
power lines, traffic lights, overhead lines of electric
railways, electric bus lines or trams, televisions, car
motors, bike computers, some motor driven exercise
equipment, cellular phones or when you walk through
electric security gates.
NOTE If the watch is kept idle without receiving a heart
rate signal for 5 minutes, the Heart Rate receiver will
turn off.
6
2006.4.24, 3:22 PM