Transmission Signal - Oregon Scientific Zone Trainer 1.0 Manuel De L'utilisateur

•
Do not wrap the chest belt in a wet towel nor with other
wet materials.
•
Do not store the chest belt in a hot (about 50°C) and
humid (about 90%) environment.
•
Do not place or wash the chest belt under running water,
instead clean it with a wet cloth.
•
Do not place the conductive rubber face down on a
metal table or surface.
•
Properly dry the chest belt immediately after use.

TRANSMiSSiON SigNAL

The heart rate chest belt and watch have a maximum
transmission range of about 62.5 centimeters. They are
equipped with the latest digital coding system to reduce
signal interference from the environment, as well as analog
technology.
Search for heart rate signal:
•
Press MODE/- to select "EXE", "HR BELT" will be
displayed shortly after to indicate system is searching
for chest belt signal.
NOTE
Whenever the watch is searching for the chest belt
signal (manual or automatic search), make sure that the
chest belt is no further than 0 cm from the watch.
Your watch will advise you which system it is using and the
signal status by displaying the following icons:
icon
(no
Signal unsuccessful?
The signal search will take approximately 30 seconds. If
after 30 seconds the "NO HR BELT" is displayed, then your
signal search has been unsuccessful. You can either:
6
Description
Searching for a
signal
(Press +/ST/SP
to skip search
and only use
stopwatch
function)
A signal has
been found and
the digital system
is being used
A signal has been
found and the
analog system is
being used
No signal has
been found
symbol)