Oil Filter Replacement - SWM RS 125 R 2016 Manuel D'utilisation Et Entretien

OIL FILTER REPLACEMENT

After draining the oil as described above, operate as
follows:
- Unscrew the two screws (1) and remove the cover
(2) by slightly turning it.
- Remove the oil filter (3).
- Check that the spring (4) is in its slot on the bot-
tom of the filter housing.
Note*: if the spring (4) exits from its slot, since is of
conical shape, place it, in its slot, with the greater
diameter so that it remains in position.
- Check the OR seal (5) conditions and replace it if
worn.
- Replace the filter (3) and assemble it on the cover
(2).
- Reassemble the cover (2) with the filter in its ap-
propriate hosing and tighten the screws (1).
1
2
3
4
5
3
2
EN - 25