SWM RS 125 R 2016 Manuel D'utilisation Et Entretien page 93

AIR FILTER CHECK, CLEANING AND/OR REPLACEMENT
To access to the air filter work as follows:
- Remove the saddle and the right lateral panel as
described in the previous paragraphs.
- Unscrew the screw (1) placed under the rear
mudguard.
- Unscrew the two screws (2) and remove the pro-
tection (3).
- Unscrew the two screws (4) and remove the
plate (5).
- Unscrew the two screws (6).
- Remove the aspiration sleeve (7).
- Remove the filter (8) from the filter box.
- Check that it's not clogged and clean it by blow-
ing compressed air from inside to outside if nec-
essary. Replace it if too dirty.
Note*: Reassemble everything in the opposite di-
rection to the disassembly paying attention to the
seal (9) conditions, replace it if worn, and that it is
correctly place in its related slot.
2
2
1
5
6
3
7
4
8
9
EN - 31