SWM RS 125 R 2016 Manuel D'utilisation Et Entretien page 113

HEADLAMP BULBS REPLACEMENT
To gain access to the healamp bulbs, proceede as
follows:
- remove the upper fastening screw (1) of the the
headlamp carrier to the instrument panuel support;
- push forward the headlamp carrier (B) and pull
it towards the high (C) in order to uncouple
from the two lower supports.
- remove the headlamp carrier;
- remove the two filaments bulb connector (2)
and the boot (3);
- release the bulb holding spring (4) and then the
bulb (5) itself.
Note*: Headlamp bulb (5) is of the halogen type; be
careful when replacing it since the glass part shall
not be touched with bare hands.
To replace the position light lamp work as follows:
- remove the lamp holder (6) and replace the
lamp (7).
After replacement, reverse operations for reassem-
bly.
1
C
B
2
3
4
4
5
6
7
EN - 51