Clutch Control; Combined Braking Control - SWM RS 125 R 2016 Manuel D'utilisation Et Entretien

CLUTCH CONTROL

The clutch control lever (1) is located in the handle-
bar left side and it's equipped with a protection.
The clutch control position can be adjusted by loos-
ening the fixing screws (A).
WARNING*: Do not forget to tighten the screws
after the adjustment.
EN - 16

COMBINED BRAKING CONTROL

The combined braking control pedal (1) is located in
the motorcycle right side. A stop switch, when brak-
ing, causes the taillight lamp ignition.
NOTE
If you pull the lever (2) you'll brake using the front
brake; if you press the pedal (1) a combined braking,
for which the system will divide the braking, both
on the front brake and on the rear one, will occur.
1
2
A
GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the
engine. The operator must release the lever after
each gear change to allow it to return to its central
position. Neutral position (N) is between the first
and second gears.
First gear is engaged by pushing the lever down-
wards; the other gears are engaged in a sequence
by pushing the lever upwards.
The position of the gear shift lever on the shaft can
be varied as follows: loosen the screw,
lever out, and place the lever in a new position on
the shaft.
Tighten the screw once operation is completed.
CAUTION*: Do not shift gears without disen-
gaging the clutch and closing the throttle. The
engine could be damaged by overspeed.
WARNING*: Do not downshift when travelling
at a speed that would force the engine to over-
rev in the next lower gear, or cause the rear
wheel to lose grip.
6
5
4
3
2
N
1
1
pull the
1