SWM RS 125 R 2016 Manuel D'utilisation Et Entretien page 95

COMBINED BRAKING UNLADEN TRAVEL REGISTRA-
TION
The combined braking control pedal (3) must have
an unladen travel (B) of 5 mm before starting the
braking action.
Should this not happen, operate as follows:
- loosen nut (4);
- operate the pump rod (5) to increase or decrease
the free play;
- tighten nut (4) at the end of the operation.
3
WARNING*: When the free play requirement is
not met, the brake pads will be subjected to
an early wear that may lead to TOTAL BRAKE
INEFFECTIVENESS.
5
4
FRONT BRAKE FLUID LEVEL CHECK
The fluid level in the pump reservoir may never drop
below the MIN notch visible on the sightglass (1) on
the rear of the pump body.
B
A decrease of the fluid level will let air into the sys-
tem, hence an extension of the lever stroke.
WARNING*: If the brake lever feels mushy
when pulled, there may be air in the brake
lines or the brake may be defective. Since it is
dangerous to operate the motorcycle under
such conditions, have the brake system im-
mediately checked by the SWM Dealer.
CAUTION*: Do not spill brake fluid onto any
painted surface or light lens.
CAUTION*: Do not mix two brands of fluid.
Completely change the brake fluid in the brake
system if you wish to switch to another fluid
brand.
CAUTION*: Brake fluid may cause irritation.
Avoid contact with skin or eyes. In case of con-
tact, flush thoroughly with water and call a
doctor if your eyes were exposed.
1
MIN
EN - 33