Removing The Rear Wheel - SWM RS 125 R 2016 Manuel D'utilisation Et Entretien

Masquer les pouces Voir aussi pour RS 125 R 2016:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

REMOVING THE REAR WHEEL

Unscrew the nut (1) of the wheel axle (3) and extract
it. It is not necessary to loosen the chain tension-
ers (2); in this way, the chain tension will remain
unchanged after reassembly. Extract the complete
rear wheel, keeping the spacers located at the hub
sides.
To reassemble, reverse the above procedure re-
membering to insert the brake disc into the calliper.
1
Note*: Do not operate the rear brake pedal when
the wheel has been removed; this causes the cal-
liper pistons to move outwards.
After removal, lay down the wheel with brake disc
on top.
After reassembly, depress the brake pedal until the
pads are against the brake disc.
2
2
3
TYRES
Care should be taken to keep the tyres properly in-
flated. See "Technical data" chart at the beginning
of the manual for correct tyre inflation pressure.
Replace the tyre if its wear exceeds reference val-
ues on the table below.
MINIMUM HEIGHT OF THE TREAD
FRONT
0.12 in. (RS); 0.08 in. (SM)
REAR
0.12 in. (RS); 0.08 in. (SM)
EN - 41

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sm 125 r 2016

Table des Matières