Pneumatic Fowler Release Handle Adjustment - Stryker 1089 Manuel D'entretien

PNEUMATIC FOWLER RELEASE HANDLE ADJUSTMENT

English
Tools Required:
• #2 Phillips Screwdriver
Procedure:
1 . Apply the brakes .
2 . Using a #2 Phillips screwdriver, loosen the two screws on the handle linkage . Release the handle tension spring
on the patient left side .
3 . Adjust the handles (B), so there is a 3/4" gap between the inner fowler frame and the handle .
4 . Tighten the two screws on the handle linkage bar and reattach the spring .
5 . Check the adjustment of the pneumatic cylinders . See "Pneumatic Fowler Adjustment" on
6 . Verify proper operation before returning the unit to service .
Return To Table of Contents
1-30
Service Information
1089-009-006 REV G
page 1-29 .
www.stryker.com