Litter Removal - Stryker 1089 Manuel D'entretien

LITTER REMOVAL

Tools Required:
• 1/2" Socket
• 3/8" Drive Ratchet
• 7/16" - 20 Fine Thread Bolt
Procedure:
WARNING
Two people are required to safely perform this procedure .
1 . Apply the brakes .
2 . Raise the litter to its highest height .
3 . Remove the mattress .
4 . Using a 1/2" socket and 3/8" drive ratchet, remove the two screws that hold the jack support tubes to the jack
shafts .
5 . Thread a 7/16" - 20 fine thread bolt far enough into the top of the jack support tubes to separate the litter from
the jack shafts .
6 . With the assistance of another person, lift the litter straight up to remove it from the jack shafts and set it aside .
7 . Reverse steps to reinstall the litter .
8 . Verify proper operation before returning the unit to service .
www.stryker.com
Service Information
1089-009-006 REV G
Return To Table of Contents
1-25
English