WAGNER Plast Coat 430 Mode D'emploi page 45

Plast Coat 430
6.8.2
RINSE THE MORTAR HOSE
(PNEUMATIC SPRAY LANCE)
Do not bend the mortar hose!
Protect it against damage, for exam-
ple against being driven over as well as
against sharp objects and edges.
Set selector switch to "F".
If cellulose paste comes out of the tip, close the material tap
(fig. 18, 1) (material tap points forwards).
material.
Set selector switch to "F".
terial tap (Fig. 18, 1).
6.9
BEGINNING OF THE SPRAYING PROCESS
Open the air flow regulator (fig. 18, 3) and the material tap
Important: Do not let the mortar spraying
machine run dry. Switch the device off im-
mediately if no more material comes out of
the tip or if the spray line becomes irregu-
lar. Possible reasons for the problem and
how to correct it can be found in the chap-
ter called „Eliminating faults".
Increased material tap wear. Do not use the
material tap to set the material volume.
The delivery volume controller should be
used for this purpose.
6.10
END OF THE SPRAYING PROCESS
Fig. 18, 1).
Always close material tap at end of the
spray process.
3
-
-
COMMISSIONING
1
POWER
ERROR
A
R F
2
GB
45