WAGNER Plast Coat 430 Mode D'emploi page 37

Plast Coat 430
4.1
OPERATING ELEMENTS AND DISPLAYS ON
DEVICE
1
2 Selector switch for operating mode
3 Indicator light (Error)
4 Operating light (Power)
5 EMERGENCY STOP switch
A
R
The selector switch (Fig. 3, 2) offers the following modes:
A
"A" position = automatic
Basic setting for control with an automatic
mote control
A
"F" position = manual activation
This setting is required for:
When using the pneumatic lance, this set-
ting is also needed for:
0-10
POWER
ERROR
F
Fig. 3, 1) is used to regulate
A
Detailed explanation of selector switch use:
If the selector switch is in the "A" position, the PC430 can be
switched on and off with the material shut-off on the auto-
4
suction unit), the machine is switched on using the "F" switch
5
position and off using the "A" position.
3
switched off to clean the mortar hose, the pneumatic lance
is not controlled using the material shut-off. In this case, the
machine must therefore also be switched on using the "F" po-
2
sition.
Important: control via the selector switch and
1
The machine can be switched from the "A" po-
sition (control using material shut-off ) to "F" at
person operate the machine.
The operating light (green, Fig. 3, 4) indicates that the machine
When the mains plug is connected the PC 430 carries out a
function check. While this is going on the indicator light (red,
stops after about 30 seconds. If the indicator light lights up
during operation, this indicates that there is a malfunction. For
detailed information about this kind of fault, refer to the „Rec-
tification of faults" section on page 49.
If the selector switch is in the "F" position when
the mains plug is plugged in, the machine will not
switch on.
-
to "F" to switch on the machine.
EMERGENCY STOP switch
When the EMERGENCY STOP switch is pressed, the PC 430 is
Turn the EMERGENCY STOP switch in order to release it again.
The machine remains switched off after release. To switch it on
to "F".
"R" position = reverse gear (must be held in
this position).
This setting is required for:
GB
OVERVIEW
37