Manual Cooking Programs - Franke CRYSTAL CR 913 M BK DCT TFT Manuel D'utilisation

EN
The probe connection
point is shown in the
figure.
After connecting the probe, insert the tip in the meat
X X
and switch the oven on.
For a correct temperature reading, the probe must be
inserted so that the tip is as close as possible to the
centre of the meat.
Select the cooking mode and temperature.
X X
The icon
„ „
connection of the probe.
If the icon
„ „
not fully inserted. Insert it properly.
The oven temperature selected must be suitable for
the even cooking required (a temperature that is too
high could burn the outside of the meat). Cooking is
interrupted in any case when the meat probe detects
the reaching of 65 °C inside the meat, regardless of
the selected oven temperature. In fact, at this pre-set
temperature the meat is cooked to medium.

MANUAL COOKING PROGRAMS

Program Description
HOT AIR
This energy-saving cooking function (1500 Watts) is generally suited for a wide variety of dishes.
Cooking times are elongated but heat distribution is optimal which guarantees excellent results at a
low power consumption.
TOP & BOTTOM HEAT
This traditional function is ideal for all dishes, for baking bread and cakes and for cooking roasts and
lamb.
FAN ASSISTED
This a traditional function is used for flans, savoury pies, desserts and roasts of for cooking on two
shelves.
PIZZA
The heating elements are combined to create highly concentrated heat in the lower part of the oven.
This function is ideal for cooking pizza which requires heating from below on a single shelf. Cooking
is quick and perfect results are guaranteed (for preheating use RAPID HEATING and then switch on
Pizza mode).
RAPID HEATING
This very powerful function exploits the DCT booster effect. High temperatures are reached in a short
time. This function is suitable for traditional cooking of large pieces of meat (e.g., leg of lamb, roast
suckling pig, pork/veal leg, oven-baked ham).
will light up, indicating correct
disappears, it means that the jack is
CR 913 M
If a different type of cooking (rare or well-done) is
required, this pre-set value can modified as follows:
Press , select
X X
required cooking level and press
Select start cooking and press
X X
The cooking program starts.
„ „
You must choose within 15 seconds using the buttons
X X
and to increase or decrease. It is possible to
select between 35 °C and 95 °C.
– 16 –
, press to confirm the
.
.