Information For Energy Saving; Overview; Oven - Franke CRYSTAL CR 913 M BK DCT TFT Manuel D'utilisation

EN

INFORMATION FOR ENERGY SAVING

The operating modes GENTLE HEAT and HOT AIR
consume less energy than the other cooking functions
available.
Avoid frequent door opening.
Z X
Preheat as rapidly as possible.
Z X

OVERVIEW

Oven

Cooling fan
In order to reduce the temperature at the door, the
control panel and the sides, your Franke oven is equipped
with a cooling fan which is automatically activated when
the oven gets hot. When the cooling fan is on, air is
vented out of the oven between the front panel and oven
door. The speed of the air being expelled was optimised
to create no disturbance in the kitchen and to keep the
noise to a minimum.
To protect kitchen units, the cooling fan continues to run
after cooking until the oven has cooled down sufficiently.
1 2 3
CR 913 M
Preheat the oven cavity only if the baking results
Z X
depend on this operation.
If a recipe for a gratin uses residual heat for longer
Z X
than 30 minutes, turn the appliance off 5–10 minutes
before the end of cooking.
4 5 6
Runners for racks and enamel trays
Used for correctly positioning the racks and enamel trays
in 6 predetermined positions (depending on model; 1 to
6 starting from the bottom). The cooking table (page 18)
indicates the best position for each type of cooking.
– 8 –
1 Control panel
2 Front door handle
3 Front door glass
4 Lighting
5 Runners for racks and
enamel trays
6 Colling fan (rear side)